Repeat difer. progams (PLATE)on 1 push (start)

4 months ago by bocchy

we have 4 tables (124 x 65 inch )with hyp. hp 400x. so if we load 4 plates of 1/2 120 x 60 we have different pieces and different client so we have 4 programs different if i copy all 4 in the 1 prgr. it will repeat just 4 time in the position (POS-1), but if we add between each programs after which we deleted (end program) go to position (pos-2) after 2 progr. go position (pos 3) after go to (pos 4) finish of cut after that (cod end program)but 4 programs in 1 it is to toooo long to load the prgrm. (piece). Exist multitask, but we need go with joystick i the (pos 2 pos 3 or pos 4) my hope is, if we have 4 different program with the same thickness 1 program = Z1 2 program = Z2 3 program = Z3 4 program = Z4 so my original program of 4 plates is 1 program = U1 but U1 = go to pos1, call Z1, go pos2, call Z2 go pos3, call Z3 go to pos4, call Z4 (end program) any ideas ? kkcdns@gmail.com thnx.

Comments

• Comment from jesse.stone 4 months ago

  Thanks for your idea, bocchy - at this point, it is not possible to call a second part program from within the first. It sounds like there may be opportunities to improve your current setup, though; I would suggest contacting your local Technical Service team (http://www.hypertherm.com/en/Company/Contact_Us/) for more information.